PIC16F785-I/SS【PDF 21/206 页】IC PIC MCU FLASH 2KX14 20SSOP

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3887

17页 18页 19页 20页 [21页]22页 23页 24页 25页

117

8272E–AVR–04/2013

ATmega164A/PA/324A/PA/644A/PA/1284/P

16.5

Prescaler Reset

The prescaler is free running, that is, operates independently of the clock select logic of the

Timer/Counter, and it is shared by Timer/Counter1 and Timer/Counter0. Since the prescaler is

not affected by the Timer/Counter’s clock select, the state of the prescaler will have implications

for situations where a prescaled clock is used. One example of prescaling artifacts occurs when

the timer is enabled and clocked by the prescaler (6 > CSn2:0 > 1). The number of system clock

cycles from when the timer is enabled to the first count occurs can be from 1 to N+1 system

clock cycles, where N equals the prescaler divisor (8, 64, 256, or 1024). It is possible to use the

Prescaler Reset for synchronizing the Timer/Counter to program execution. However, care must

be taken if the other Timer/Counter that shares the same prescaler also uses prescaling. A pres-

caler reset will affect the prescaler period for all Timer/Counters it is connected to.

16.6

Counter Unit

The main part of the 16-bit Timer/Counter is the programmable 16-bit bi-directional counter unit.

Figure 16-2 shows a block diagram of the counter and its surroundings.

Figure 16-2. Counter unit block diagram.

Signal description (internal signals):

Count

Increment or decrement TCNTn by 1.

Direction

Select between increment and decrement.

Clear

Clear TCNTn (set all bits to zero).

clk

Timer/Counter clock.

TOP

Signalize that TCNTn has reached maximum value.

BOTTOM

Signalize that TCNTn has reached minimum value (zero).

The 16-bit counter is mapped into two 8-bit I/O memory locations: Counter High (TCNTnH) con-

taining the upper eight bits of the counter, and Counter Low (TCNTnL) containing the lower eight

bits. The TCNTnH Register can only be indirectly accessed by the CPU. When the CPU does an

access to the TCNTnH I/O location, the CPU accesses the high byte temporary register (TEMP).

The temporary register is updated with the TCNTnH value when the TCNTnL is read, and

TCNTnH is updated with the temporary register value when TCNTnL is written. This allows the

CPU to read or write the entire 16-bit counter value within one clock cycle via the 8-bit data bus.

It is important to notice that there are special cases of writing to the TCNTn Register when the

counter is counting that will give unpredictable results. The special cases are described in the

sections where they are of importance.

TEMP (8-bit)

DATA BUS (8-bit)

TCNTn (16-bit Counter)

TCNTnH (8-bit)

TCNTnL (8-bit)

Control Logic

Count

Clear

Direction

TOVn

(Int.Req.)

Clock Select

TOP

BOTTOM

Edge

Detector

( From Prescaler )

clk

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式